Answer / suresh

Pressure Transducer is a device that converts one form of
energy(pressure) into elctrical signal.
Pressure Transmitter is a device whcih is transmits the
converted (electric signals)signals from Transducer.

Answer / sam

Transducer is any device that can converts one type of
energy into another type of energy. In a pressure measuring
instrument the transducer is the actual pressure cell that
converts the measured pressure energy into a proportional
electrical energy.
This pressure cell is connected via a ribbon cable to the
head of the pressure measuring instrument where the
transmitter is situated.
Transmitter is any device that can take a generated signal
and transmit that signal via any means, be it via cable or
radio waves to a receiver.
We normally refer to any measuring instrument's transmitter
section due to it being the most important area to us. The
transmitter's ability to transmit the generated 4 to 20mA
signal is what we work on and not the cell or transducer area.
If you talk about your car do you talk about your 4 cylinder
or do you talk about your Toyota Corolla?
Good luck

Answer / alfred t jose

Transducer is a device that can converts one type of
energy into another type of energy. pressure transducer
converts nonelectrical energy to electrical energy.
transmitter is a device that can transmits these electrical
energy.

Answer / chetan

pressure transducer sences pressure and gives output in
electrical form if using active transducer
pressure transmitter transmits the pressure measured in
electrical form but after amplifying for sending this data to
remote(far distance from workstation) location.

Answer / ram

Pressure transmitter are same working as pressure Transducer but basically differences is that in plat used Plc. So plc working in digital signal. So we can say transmitter is convert pressure ( flow energy) in to pluse from ( electrical signal) in plc.

what r all the type of viberation measurement measuring in turbin? what's the output of viberation sensor?

2 Answers  

What are different types of valves?

0 Answers  

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers  

1.what is the role of proportional comtroller in pid controller?2.How do u calibrate the control valve?

3 Answers   Bently, IOCL,

how to calibrate displacer type level transmitter by dry weight method please mention formula for weight calculation

1 Answers  

what is the difference between auto tuning and manual tuning of controllers(eg:PID,PI,PD CONTROLLERS )

2 Answers   GATE,

What is the difference between a Extension cable and a copnesating cable.Where can we use compensating cable. Is anywhere compensating cable are used for mv transmission to the indicator.

1 Answers  

how micro-processor and micro controller different from architecture

3 Answers   Bhushan Power Steel,

why the steam drum and deaerator level transmitter range is in negative MMWC to zero

3 Answers   Emerson, Jindal, JKPM,

What is surge in compressors? How to detect and control it?

3 Answers   Kharafi National,

What is diffrence between Transducer and Transmitter?

13 Answers   Ford,

WHAT IS DIFFERENCE BETWEEN TWO WIRE RTD AND THREE WIRE RTD?

5 Answers   Yokogawa,