What is the % number of various buses in a typical power system?

What is the % number of various buses in a typical power
system?

Question Posted / iamdon

2 Answers
4694 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the % number of various buses in a typical power system?..

Answer / iamdon

Any power system has three buses namely with following
stakes in general.

1)PQ bus or load bus-------85% approx
2)PV bus or generator bus--15% approx
3)Slack/Swing/Reference bus-1 in number.

Author:arbelectbit@yahoo.com

Is This Answer Correct ?

5 Yes

1 No

What is the % number of various buses in a typical power system?..

Answer / gaurav

MOST OF THE BUSES ARE LOAD BUSES ie PQ buses

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why is tan-delta test and capacitor measurement done on alternator?

0 Answers TD Power Systems,

Why we cant store an ac power. If we coo store in which device we can?

0 Answers Jindal,

Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . please reply..............

9 Answers NTPC,

DIFFERENC BETWEEN VOLTAGE AND CURRENT

1 Answers Wipro,

The capacity of the transformer is 20/25 MVA, Ratio is 132/11 KV, Vactor group YNyno. and impedance is 10.07%. As per the calculation the secondary current is 1312.2Amps. The maximum fault current the transformer should sustain is 13.030KA. How many times the transformer should sustain the maximum short circuit current of 13.030KA over a period up 1 Year. The transformer is repaired one & 10 Years old.

1 Answers

Explain Clearly Pahase and Neutral?

7 Answers

How to calculate the slip ring induction motor rotor current and voltage.

1 Answers Bhel,

what is the saturation point of crgo lamination.

0 Answers

can we use the same fuse for both ac and dc?

3 Answers

What is the meaning of 'A synchronous motor floating on line'?

2 Answers

How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?

0 Answers

Hi friends. is it possible that SCADA System through RTUs can connect Via PLCC Communication carriers ? thanks

1 Answers

For more Electrical Engineering Interview Questions Click Here