Answer / iamdon

By employing super critical technology( Temperature more
than 600 degree celcius and pressure of steam 30 N/mm2 )
overall efficiency upto 50% can be achieved but in rest of
the cases the efficiency is well below 50%.
The range of efficiency of steam power plants is 30-50 %.
The typical value is 35%.

The reason of low efficiency is statistically stated as.
Approx 10% of heat is lost with flue gases.
Approx 50% of heat is lost in condensor.
These two are mainly responsible for low overall efficiency
of steam power plants.

Thermal cycle(Rankine cycle) efficiency=30-40%
Generator and Turbine efficiency=90% +

Author:arbelectbit@yahoo.com

Answer / nitin sarda

Nice answer

How to reduce current flowing in neutral due to unbalanced load conditions in a three phase system.

1 Answers   IOCL, wbsedcl,

---

What is the purpose of SOTF being used inspite of distance Protection given?

7 Answers   Alstom,

---

3. What is Impedance Voltage in Transformer?

16 Answers   KESC, L&T, Torrent Power,

---

Why the Potential transformer Primary in connected to Earth?

2 Answers  

---

now a shunt motor is practically a constant speed motor , then how does it meet the increase or decrease in the load ?

1 Answers  

---

in 4 pole lap wound dc motor one brush is disconnected then what result in new voltage if its voltage is v volts power is p watts current is i amp

1 Answers   GATE,

---

what is the kvar, droop, stability,ramp

1 Answers  

---

What is the most essential condition for the voltage build up for a d.c. Shunt generator?

0 Answers  

---

How can I known multiplying factor .without multiplying table

0 Answers   Student,

---

diffrence between alternating and pulsating field?

1 Answers  

---

How can you justify a fully carged battery by physical checkup ?

12 Answers   Indian Military Services,

---

Operation carried out in thermal power stations?

0 Answers  

---