Answer / abdul wajid

Yokogawa India Limited, Bangalore - DCS,PLC,SCADA,Field bus
engineering)

ATI Chennai - PLC, SCADA, Testing & calibration of
industrial instruments(temperature & pressure)

FCRI, Palghat

Answer / edgardo ramos

Evev if you enroll in a good and expensive institute but if
you are not interested to learn,its useless.

Answer / salim

In indusries where we can see real time application of
electronic devices as well as instruments thats why ind
experince is better than to join training institute.

Answer / lijo john

Better go to any industry for 3 or 4 months training

Answer / murali inst. technologist

ATI -- HYDERABAD

A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.

0 Answers  

what is all types of analyzer in water production plant?

1 Answers   Marafiq,

Sir, my yokugava FF TYPE LEVEL transmitter us bad, i don't have spares available, i want to replace it with a Rosemount FF transmitter, please tell me what procedure to be followed and what changes to be done in dcs part.

1 Answers   BPCL Bharat Petroleum, OEG,

what is the reset offset and control system in instrumentation

0 Answers   ABB,

what should be minimum length and size of impulse line for steam flow orifice and feed water orifice? asked by sanjay parihar

1 Answers   Birla,

why we use -ve voltages in vibration prob?

1 Answers  

How is automatic reference junction compensation carried out in temperature recorders?

0 Answers  

WHAT PRINCIPLE OF GAS ANALYSER( CO,CO2,N2)

2 Answers   Jubilant Organosys,

dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,

0 Answers  

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

how can be connected thermocouple in series?what is the need?

2 Answers   Hindalco,

I have a LT of 10000mmwc range. can i use this LT in 1000mmwc range of tank?? if yes than what happened???

3 Answers   Nirma,