What will happen if we give transformer a dc not ac

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / yogesh

5 Answers
9831 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What will happen if we give transformer a dc not ac..

Answer / iamdon

If we supply DC to primary of transformer no emf is induced
in primary side(Accordibg to Faraday laws).It means whole
applied voltage is droped in primary winding resistance
which is very low.So high current will flow through the
primary winding which ultimately burn the primary winding.

Is This Answer Correct ?

20 Yes

0 No

What will happen if we give transformer a dc not ac..

Answer / shariff

If DC is applied to the Power Transformer, this is basically a inductive coil, as freq. is zero is DC, inductive reactance offered is zero i.e. XL=0, then it is as good as short circuiting the DC power supply, if the DC power supply can feed that much current, then that power transformer wdg will burn or due to its resistance the wdg may get heated up.

Is This Answer Correct ?

7 Yes

0 No

What will happen if we give transformer a dc not ac..

Answer / chatap

No flux will generat and primary takes high current and may burn

Is This Answer Correct ?

7 Yes

2 No

What will happen if we give transformer a dc not ac..

Answer / jyoti

NO FLUX WILL TRANSFER FROM PRIMARY SIDE TO THE SECONDARY
SIDE.HENCE THE TRANSFORMER DOESN'T PERFORM.

Is This Answer Correct ?

5 Yes

2 No

What will happen if we give transformer a dc not ac..

Answer / aravind

if current is very high it may burn out the windings
but if current is low then primary winding acts as an inductor

Is This Answer Correct ?

4 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What is the working principle of ceiling fan?

6 Answers Indian Navy,

how many electricity poles are there and what are the names and their sizes.

0 Answers

hi friends can u tell me name of the sites where i can get animation of electrical machines......

1 Answers

what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?

0 Answers

why current increases when voltage decreases in ac system

10 Answers

IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace.

1 Answers Jindal,

What are the characteristics of negative feedback?

0 Answers

what is power factor

4 Answers UltraTech,

what is the criteria for selection of conductor used for ehv ac electrical dischrge

0 Answers National Productivity Council,

what is static frequency converter?what is the function...of sfc...?

0 Answers L&T,

What are all the points to be checked while decanting diesel from tanker lorry to HSD YARD

1 Answers Cisco,

Why do u join toreent power ?

1 Answers

For more Electrical Engineering Interview Questions Click Here