what is basic working principle of Governer in power plant?

Question Posted / dinesh sarshiha

3 Answers
8999 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is basic working principle of Governer in power plant?..

Answer / vaibhav v t

Auto regulation of steam pressure/flow with respect to
speed of the turbine.

Is This Answer Correct ?

18 Yes

0 No

what is basic working principle of Governer in power plant?..

Answer / narendra mishra

it controls the MW generation according to the steam
flow,pressure.

Is This Answer Correct ?

4 Yes

3 No

what is basic working principle of Governer in power plant?..

Answer / prashant g kurhade

Governor is used to control the rpm of the steam turbine by throttling the inlet steam.
Woodword governors are most widely used in industry
it senses the rpm n drive a hydraulic pump which is inbuilt in governor and develope the oil pressure such that the generated oil pressure will control the steam valve
now days electronic governors are there which gives mA output and through I to H or I to P you can convert it to pressure and control the steam inlet valves.
please read woodwords manual for more details thank you.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

What is super thermocoupal?

0 Answers Emco,

where cascade loop use ?

0 Answers KNPC, KOC,

I need circuit for RTD senser?

0 Answers

what are the types of a thermocouple

2 Answers

a laways iface problem with brine level transmitter sealing diaphram a laways giving error and maximum reading i made re range and adjust with side glass but during commission it giving gap reading between it and side glass i need help from expert to explain how to calibrate it. note:dp transmitter yokogawa company

1 Answers

flow transmitter formula?

0 Answers BEMCO, Siemens, Yokogawa,

How to ensure vibration sensor functioning accordingly.With out using an other sensor.

3 Answers ACC, Oil India,

what is the zero elevation and zero supresstion in level measurement, how can use it?

2 Answers GAIL,

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers

what is datum line?

4 Answers

If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?

0 Answers

What s PDS & PDMS tools ?its role in instrumentation?

1 Answers

For more Instrumentation Interview Questions Click Here