difference between span and range

Question Posted / naresh

3 Answers
17130 Views
IOCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

difference between span and range..

Answer / naresh

range is the values between which the system is performing its functionality properly according to the specifications

SPAN IS THE DIFFERENCE between higher range value and lower range vale

Is This Answer Correct ?

35 Yes

2 No

difference between span and range..

Answer / uday

Span is a algebraic difference between the limits of the range from zero to full scale.

The range is that difference in minimum and maximum operating parameters that the instrument will withstand without damage.

Is This Answer Correct ?

5 Yes

4 No

difference between span and range..

Answer / jobin

Dear uday...how can u say that..LRV is always zero...span is the algbrc differnce of UrV and Lrv.that doesnt mean LRV is zero.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

which instrument is most commonly used to observe the external features of a grasshopper's abdomen?

1 Answers

y v r connecting 250 ohms resistor in series when u cummunicate with BT in bench calibration?

5 Answers

what is the PID controller?

1 Answers

What is fault tolerent system

2 Answers GNFC,

can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.

0 Answers

What is the purpose of MATLAB?

3 Answers

Is there any temperature compenasation for the air flow from FD fan & SA fans which supplies air to the Boiler?

2 Answers

what sud u do if u dont get feedback from control valve?

1 Answers Siemens,

what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?

0 Answers

What is duty of as-built engineer.

2 Answers Sofcon,

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers Gasco,

what is the difference between SCADA and DCS?

5 Answers ACC,

For more Instrumentation Interview Questions Click Here