Answer / satya dev

Basicaly Transformers having two type of tests 1-
Manufacturing & 2- Field test, Manufacturing test are
described Above & Field tests are carried out during the
Commissioning at site.Field tests are given belwo..

Insulation Resistance Test- Phase to Phase, Phase to Earth,
Winding Resistacne Test.
Testing & setting of WTI & OTI.
Vector Group Testing.
Magnetinc Ballance Test
Ratio Test.
Knee Point Test.
Tan Delta Test ( This is Also IR test)
Hi Voltage Impulse Test (if Client requested)
etc...

Answer / amit ganorkar

ratio test,magnetic balance test,2 kv test,insulation
resistance test,resistance test,separate source
test,induced over voltage test,vector group test,no load
test,short circuit test, these are routine
test.temperaturise test,pi test,noise level test,tandelta
test these are customer requirement test

Answer / sumit shukla

short ckt test measure eddy current loss,hystresis loss
open ckt test measure omhic loss
back to back test

What is meant by sotf,lbb,power swing,pole discrepency,auto reclose?

1 Answers   Bunge, Electrical, Omega, TCS, TNEB Tamil Nadu Electricity Board,

---

If current and resistance in a circuit is increased by 20%, what will happen to its voltage drop??

4 Answers  

---

What is the Ideal Earth to Neutral Rating for Techonology Equipment like Routers, Switched, PABX, Computers etc etc?

2 Answers  

---

what is the procedure for cable sizing or on what basis we will calculate the size of cable?????

6 Answers   ANG, Focus, Mecon,

---

why dont we connect the two 12 V DC batteries in parallel, for an inverter (UPS)? is there any harm ?

6 Answers  

---

what is meant by GD2 ?

1 Answers   Kirloskar,

---

how does ELR works? explain

0 Answers  

---

what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.

0 Answers   Bajaj,

---

. Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person

2 Answers  

---

Why OLTC(On Load Tap Changing)transformer is not recomended for improving voltage instability?

2 Answers  

---

what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator

0 Answers  

---

In DC motor,the field MMF is given by NI.N-no.of field winding turns,I-excitation and both are constant.Then how could the main flux decreases due to armature reaction.

4 Answers   Bhel, IBM,

---