which is better 50 HZ supply or 60 HZ supply?
Answers were Sorted based on User's Feedback
Answer / vivek
50Hz is more economical to generate, transmit and use than 60Hz frequency
It may also be interesting to note that while India uses 50Hz, USA can afford 60Hz.
| Is This Answer Correct ? | 5 Yes | 3 No |
Answer / mak
Generally US use 60 Hz Frequency because mainly for the safety purpose.Most of the transmission in US are through underground cables ..So For the safety purpose they are using 60 Hz.Where india the grids are limited to transmit limited voltage .So When the grids are nationalised we can also use 60 Hz
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / s.arul
60 HZ supply is best to compare than 50 HZ.
if use 60 HZ, grid & all area voltage level come to down
wards so, transformer size is less, only one disadvantage
is generator speed increase.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / amarnath
Ideal frequency for operating to gain no losses and perfect
voltage is 49.5 to 50.5 Hz.
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / dinakar
50hz is better than 60hz because...by increase in frequency
electromagnetic radiations may occur and also transformer
efficiency decreases
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / manju
both r same, india adopted 50Hz and USA can afford 60Hz.
| Is This Answer Correct ? | 0 Yes | 4 No |
What are the types of AMF(auto main failure) panel.
What is the function of Buchholz relay in transformer ?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
what percent do you derate your copper wire when you change from copper buss to copper wire
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
sir i want previous entrance exam papers for written test
why transformer cannot rotate though the princplebehind induction motor is similar to a transformer?
In CT,which terminal(s1,s2) need to be grounded?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
in ONAN type transformer winding temperature is lower than oil temperature at evening time but morning winding temp is higher than oil temp what is the reason?
Write a note on RC operational amplifier as integrator
Why Current Transformers cannot be connected in parallel
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)