Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amarnath
Ideal frequency for operating to gain no losses and perfect
voltage is 49.5 to 50.5 Hz.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the basic of DTH.
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
what is under coal gassification?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
how to check avr of dg set of 125kva
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
What is steady state response?
why there using acb enclosure in big buildings
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
does a DG set has low fault level as compared to that of a transformer.If yes then why.
What the difference between ac and dc inductor an capacitor
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
Discuss about gear cutting machines.
