How many methods to take IR value of Current Transformer?
Answer / sunilgautam22
It is Taken by three mwthods. these are following
Primary to Earth
Secondary to Earth
Primary to Secondary
Is This Answer Correct ? | 20 Yes | 2 No |
why capacitor do not switch ON the DG power? (I had checked, capacitor ON in DG power that time current rating was reduced.)
What is the Difference Between choke & ballast
3 Answers ABB, ICS Integrated Computer Solutions,
how to improve power factor correction?
New istallation how many eathing have one transformer? Names of earthing connect places?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
What is high frequency grounding????Applications........
if a motor has 1500rpm then what will its HP?
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
Why used in layer by layer charcoal and salt used in earth pits.
11 Answers CESC, HP,
What is shutdown of electrical sub station?
We have .ht motor which is 60Hz.we run on 50Hz.so that it's speed reduce but we had one prob.that motor winding temp increase up to 135 deg.we want reduce this temp.what to do?we arrange ext.cooling fan but not much effect.we want reduce this temp. Inhouse without affecting much.cost. also don't want reWINDING OF MOTOR?