Answer / rahul ganthade

this is due to the form factor=avg value/max value

Answer / sudhir sudhakaran

The Form factor = Average Value/RMS Value being 1.11
hence which is multiple of 11 , hence 11, 22,33,66,132,220
kV . In fgenerating stations we get o/p voltage of 6.6 kV
which is Stepped Up to 11 kV.

Answer / rahul j

to maintain the phase angle differnce.

Answer / amit sonmale

BCAus In Some Other Country They Use Poly Phase For Their
Eficiancy

Why we use DC for charging of Batteries??Why not AC Supply???

6 Answers   Emerson, Infosys,

---

Explain REF protection and sbef protection in transformer?

3 Answers  

---

what is the diff between earth leakage relay and earth fault relay?

7 Answers  

---

wht factor are considered to design ACB( air Circuit reaker) 415V

3 Answers  

---

WHAT SHOULD BE THE MINIMUM IR VALUE FOR LV (380V) CABLES ACCORDING TO IEC/IEEE.

3 Answers  

---

what is the function of Droop CT and where it is used?

3 Answers   Lanco,

---

in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses?  the second question is-generation is depends on LV winding? or LV winding design for generation voltage?

0 Answers  

---

What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.

0 Answers  

---

why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points

0 Answers  

---

why earth wire is needed in a wiring system

1 Answers  

---

Expand sqcm?

2 Answers   UltraTech,

---

What is safety of Ht panel

0 Answers  

---