WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
No Answer is Posted For this Question
Be the First to Post Answer
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
which connection is safer series or parallel?usually which connection we prefer at home?
why transformer is rated in kva instead of kw?
What is the feedback in the control system?
how the transformer stables out zone faults? Because we use non directional O/C relays .Is there any special considerations are taking into account to overtake this?
hello every one, what is the difference between the Kvar and farads, Rating on Power capacitor is for eg: x kvar, and normal capacitor is eg: x farads. what is the relation between these two?
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
why do we require two lines one phase and a neutral for an ac transmission..is neutral potential zero..?if yes y carry a neutral line from generating station itself...why dont we take it from ground
374kvar capacitor bank connected across 600kw,6.6kv motor.what will happen if motor run at 50% , whether full kvar applied or half?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
Wat is the best to use in a generator a 6.5kva or a 7 kw
what is charger supervision and control supervision?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)