What are the insulation standerds for eg H clase and how
many insulation standerds are there and its standerds??????
No Answer is Posted For this Question
Be the First to Post Answer
What is the deffrence between Siemens S7-300 & S7-400 PLC?
How many straight through joint is permissible in single core 33kv XLPE cable for a length of 985 mtr.
at which voltage level arcing ground is occurs ??????????
Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?
Why overhead transmission line in triangular shape?
what are factors to be consider in electrical installation like load factor,diversity factor .....
What is the permissible maximum flux density in transformer core?
How many no. of earthing pits required for commisioning a new 320KVC DG Set????How????
If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units
what is cro
What is difference between dc three point starter and dc four point starter?
How can we select a capacitor Bank.? i need a standard formula for that.?
3 Answers ABB, Ace Info, HAL, IKK, MahaGenco,
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)