Answer / amardeepsingh

short ckt is dangerous in series...........bcoz alll the
equipment get damaged.....thagts y our home has all wiring
in parallel......

Answer / amit

short circuit is more dangerous in parellel
circcuit,because in parellel circuit more no of equpment
get effected whereas in series only shortcktd. part get
affected.

Answer / vksumanth

ph-------o-------o-----o------n
in the above fig shows series combination, if any short occur in the circuit current increases and fail starting element only ckt opened.
-------o---------/
/ parallel /
/------o---------
u r understanding from above fig suppose branch1 element may short occur current raised in that branch ,because v same i not same.remaining ckt healthy.
SO IAM TELLING CLEARLY DANGER IS SAME ABOUT LOSSING OF APPARATUS.BUT IN PARALLEL ONLY SHORT BRANCH DAMAGED AND INTRUPTED REMANING BRANCHES OK.GOOD

Answer / murali boopathi

Short circuit is dangerous in series circuit... Because current remains same for all loads that are connected in series. So all the loads wil be affected... Whereas in parellel circuit voltage remains same for all load and current wil be different. It depends on the load. If any fault occurs in a parellel circuit, the load which is having low resistance wil be affected... Nt all loads...

Answer / rajib

Series ckts are effected more than parallel.

Answer / luqman ahmad(farhan)

short circuits are dangerous in both the circuits but more
serious in parallel because all the loads connected are
bound to be instantly affected,on the other hand in series
the first load is affected first and the circuit fails to
function.

An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.

0 Answers  

what is mean by parallel operation of permanent magnet generators

0 Answers   PSD,

In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.

0 Answers  

voltage of a ckt is measured by volt meter having an input impedence camparable with the out put impedance of the ckt Eror caused is 1. Gross Error 2. Errors due to lloading effect

2 Answers   GATE,

last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the primary of delta transformer. we get 33A at the primary of the R phase star end. but we get 380A at both R an B in delta side. how and why?

1 Answers   Siemens,

What is RTCC panel and why it is required

31 Answers   RTCC, Tivoli Grand,

what is a DLC?[just dont reply its a Dual loop controller!] Plz do Explain the advantage of DLC over PLC?

3 Answers   Essae,

if 50hz transformer is required to be run on 50% frequency what needs to be done???????????

6 Answers   century,

how to calculate the size of the cable for a particular rating 3phase induction motor?

1 Answers   Godrej, Megatron Solutions,

what is the differnce between high impedance relay and low impedance relay

4 Answers   Areva,

Is it advantages of having star-delta vfd than normal star vfd , if yes why?

0 Answers  

Can we use 11kv Trivector Metre or Energy metre instead 33kv Metre at 33kv Over Head Line metering purpose?

5 Answers   Bhel,