last week we did the REF relay test by closing single pole (R phase) of CB and

last week we did the REF relay test by closing single pole
(R phase) of CB and apply 380V at the primary of delta
transformer. we get 33A at the primary of the R phase star
end. but we get 380A at both R an B in delta side. how and why?

Question Posted / abdul

1 Answers
3158 Views
Siemens, I also Faced
E-Mail Answers

last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the pr..

Answer / k.prakashchandra

Please edit the question.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why there is no provision of breaker in between primary of UAT and generator

1 Answers

what are the specifications we must look at to select a relay for any capacity motor?

0 Answers

Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?

0 Answers

what is the difference between torque induced and torque load?compare them with respect to dc motor?

0 Answers

The advantage of free wheeling diode in a Full Ware rectifier is -reduces the harmonics -Supplies the voltage at negative vlotage

4 Answers GNFC,

Vaccum circuit breaker

0 Answers

what is PI value and its significance for insulation testing?

3 Answers

If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.

0 Answers

1 ton AC takes how much current( starting & stable)

15 Answers

What is Servo Ventilated Motor?

0 Answers L&T,

what will happen if one of the phases from a 3-phase motor is disconnected?? stop/run at 2/3rd speed or run at same speed????

3 Answers

what is the pressure of vacuum circuit breaker

2 Answers

For more Electrical Engineering Interview Questions Click Here