when the PFR (POWER FACTOR REGULATOR)change a step to zero,one of the RCCB will triped off,is it the changing step of this PFR effect the RCCB?
2 4424Why in earthing, the earthing plate is put in vertical position? and further what is soft coke that is used in earthing?
3 13219what type of protection and safety req. in the 220kv substaion and area around the substation
2 9559What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
1819I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
1908We have 250 KVAR cacitor bank & our average load is 200kva but our power factor is average 0.66 how can we maintane it? how can we balance our load?
4 9209Post New Electrical Engineering Questions
send me all basic electrical question and answers
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
List the advantages of star-delta starter with induction motor?
what is the ATS .And how it works.
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
Safety of dry type transformer
can some one clearly explain why -48 volt DC use in telecom site????
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
what is electrical machines
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
how the characterstics of control valve being done
what is the saturation point of crgo lamination.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen