Interested to Buy Any Domain ? << Click Here >> for more details...
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
1982what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
DVC,
3294725KW Three DG set Synchronised but DG no-1 power showing 750KW DG n0-2 power showing 500KW DG no-03 showing 500KW. DG is Shynchronised but why this different power showing?
3 6008WHY WE ARE DOING THE EARTHING IN A SYSTEM. SOME PEOPLE ARE TELLING FOR PROTECTION. WHAT PROTECTION GIVE ME THE CORRECT ANSWER.
2 4755What is the use of Exciter in generator? & what will be the current of Exciter in 500 KVA DG Set?
2 9969why the active power flow of some line is increased when the active power of out is cut ?
TAFE,
2124i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?
1 3709A 60W,250V bulb when connected to a 230V supply will it give more light or less or will be give normal light?
3 6951Post New Electrical Engineering Questions
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
What are dcs and plc?
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
how do we calculate length of starting time and repeated starting of a direct online starter?
What is meant by vector group
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
difference between semiconductor & conductor & insulator?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What is the difference between DOL starter and star delta starter
I want single line diagram for AMF & DG syncronizing panel
How can we choose the rating of submersible motors
What are linear and non-linear systems?
What are the advantages of nichols chart?
how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids
What is the difference between earthing,ground&nutral?
