WHY WE ARE DOING THE EARTHING IN A SYSTEM. SOME PEOPLE ARE
TELLING FOR PROTECTION. WHAT PROTECTION GIVE ME THE CORRECT
ANSWER.
Answers were Sorted based on User's Feedback
Answer / aladdin
hi,
earthing one of the most important protection in your system it protect human of the static voltage that occur in ur system that might kill in some cases and it protect the signal of the electronic devises from noise and damage.
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / s.sakthivel
Basically three type of fault develop in the circuits
1, open circuits
2, short circuits
3,loose conection
4,body short
first three electrical fault are directly not distrub humen
and apparatus and last one (body shor) fault is directly
distrub humen and apparatus
so , body short fault time current is to discharge to
ground by the root of earth electrod, so we are addapted
every apparatus earthing system(vanthni@yahoo.com)
| Is This Answer Correct ? | 1 Yes | 2 No |
When both contractor star & delta is hold in star delta motor ?? So what happen in this case ??
what is the working of air compressor.
what happens when we give supply to the secondary of a transformer ?? for example 415v(pri)/110v(sec)
what is the difference between neutral and earth
A d.c. Shunt motor is found suitable to drive fans because they require?
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Explain why the Voltage drop will happen in 3 Phase line?
why phase to phase voltage is 400v while phase to neutral is 220v?
what is the difference between 2phase & 3 phase?
Why should we use Star-Delta connection in step down power transformers?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)