In HT overhead line why should provide top conducter which is not connected whith insulater..?
3 6477Why stand-by earth fault relay and restricted earth fault relays are connected between neutral and ground in transformer?
1 5775Post New Electrical Engineering Questions
What is the unit of charge and current?
what is the function of Moulded case circuit breaker, why it is called Moulded?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
what is the meaning of 5% droop or 7% droop in AVR?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
Motor,transformers,capacitor tubelight etc....
What is ST and specify its range of voltage.
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
how to flameproof electrical motor on the shaft?
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?