In an ammeter used for measurement of current, what is the meaning of the representation of range as '0-50-300'?
4 9186what is the difference b/w neutral and earth?what is the need of earthing and what are the different methods for earthing?
NTPC,
4 7589Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
1987if voltage in transmission line more than current will be more or less,if less what about the Ohm's law
2 5127Post New Electrical Engineering Questions
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
What is the difference between diode and a transistor in terms of the direction of current flow?
what is ratio of copper wire size and current ?
Is it possible to connect a safety device in to parallel?
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
what is effect of leading power facter on the system and billing
Differenciate between circuit wiring and sub main wiring with illustrations
what is the difference between interconnection and intraconnections in the circuit diagrams
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
what is ic 01,ic 06 ?is it types of cooling?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
can i connect the two phases of scott connected transformer,if not why?
draw singleline diagram of star to delta and dol starters