Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
2017Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?
3 5957why it is mentioned as 8/10 mva transformer why not directly 8mva or 10mva transformer. please explain me the full detailed reason.
4 9356
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
How to calculate plastering for elevated water storage tank
can we compare the combined core of DBM and BC density with average density of Lab DBM and Lab BC density
How to Calibrate Ultrasonic flow Transmitter in Field
Why is over-pressurizing an air conditioning system bad?
What is a repeater?
what is an excitation table?
Why should you chosen this job
How to calculat the ratio of HT\LT in energy meter
States some of the tool bars used in cad?
why Lightening Arrester Probe sharp at Top of telecom tower.
What are the causes of positive and negative propeller slip?
working of tuch screen pannel
what are the differences between malloc() and calloc() in c language?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.