Answer / rax

first of all it si wave trap. now for communication purposes of tele \protection a high frequency wave is superimposed on the power wave.in wave trap there is a high frequency filter but lets say it is a capacitor .now you can see when high frequency signals come the impedance of the wave ttrap is near about zero. but for power frequency signals it is very high.this is how it works

Answer / suresh

Actually the Line traps are connected with HV netwoks, It
blocks the carrier frequency to pass through in unwanted
direction and make those sigals to pass in desired direction.

I need to know how it blocks the signal..?

What is an alternator impedance value?

0 Answers   Orchid,

---

Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.

0 Answers  

---

1 HT service how many LT Service

1 Answers  

---

what are the colour's and their indications in bucholz relay?

4 Answers  

---

can transformer work on dc or not?if we increase the inductance of transformer can it happen to work on dc?

1 Answers  

---

Do power transformers have an Automatic Voltage Regulator (AVR) just like the alternator/generator in a power system?

4 Answers  

---

HOW TO FIND THE PRIMARY AND SECONDARY OF TRANSFORMER(IN OFF CONDITION) USING MULTIMETER? IS IT POSSIBLE FIND BY SEEING RESISTANCE???

4 Answers   Areva,

---

What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!

0 Answers   IFFCO, IIT,

---

I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)

1 Answers  

---

What_is_mean_by_negative_dc_voltage? why we use -48v except +48v in DC power supply systems.

2 Answers   APEL, BSES,

---

I have 200 KVA Isolation Transformer for UPS input side. & ups was having 48% load, suddenly got short what will be the reason.

1 Answers   Mukand,

---

which meter used to measure a flus

2 Answers   RRB,

---