im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much

2094

pls send me the placement papers and anyother useful information to sureshec127@gmail.com. STREAM: ELECTRONICS AND COMMUNICATION

1869

DEAR Friends, If you any of them have previous placement papers or interview papers...plzz forward it to my mail id. "rajeevasv@gmail.com"........... Tank you

2109

Hi friends,anybody can send me previous HAL interview question paper OR all other interview question paper. To, yogeshnature@gmail.com

2174

Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com

1979

PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com

5516

can anybody send me the technical papers of hewitt associates pls...I cleared aps n GD n has only less time for technical round?

2277

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2245

Dear All,I have RRB exam on 19th dec Plz send me the Last 5 years RRB Q&A of Electronics & communication Dept to mail id sham28sharieff@gmail.com.. please frnds if u do have the Q&A.. Plz send it..

2711

What types of high speed CMOS circuits have you designed?

2205

which fit is this 177-S6?

2158

i am preparing for motor vehicle assistant inespector please send me old questions papers.

1998

Kindly post me previous year interview questions with answer for post of DY. Manager (civil engg.) for GAIL, NTPC, IOC, OIL and ONGC etc.

2418

Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0

3749

plz send jto previous papers

2099