Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohit
It will depend upon load connected to DG.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the use for cable entry in control room?
Explain the different regions in frequency response?
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
What is bode plot?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Explain about p.t?
what are the advantages and disadvantages of oil filled cables over XLPE cables
Name of the relay of low lub oil presuure in DG sets
.php|
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
howmany electrician should maintain for a 1000 kva used plant... in kerala..
what is the difference b/w UHVDC and HVDC(LIGHT)?
what is mean by dry frequency
