why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
No Answer is Posted For this Question
Be the First to Post Answer
Why substation battery room is coulered black?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Why do we have 110V, 230V, 415V etc. in electrical transmissions? Why not 100V, 200V,400V?
what is the difference b/w single and three phase circuits?
comparision between mcb,mccb,elcb,flcb,elcb in details
why motors are rated in hp?
what is difrent between earthing and ground
capacitor is load free component but why ampare meter shows the current when the capacitor bank breaker close?
what is the principal of ceiling fan and how it will rotates? what is the magnetic momentum produces inside the fan?
what do u understand about FACTS? how they are useful?
Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?