Answer / ashish khatana

redundancy is the duplication of critical components of a
system with the intention of increasing reliability of the
system, usually in the case of a backup or fail-safe.

IF IT IS FOR SOFTWARE THEN IT IS SOFTWARE REDUNDANCY(LIKE
BACKUP OF DCS)

IF IT IS FOR HARDWARE THEN IT IS HARDWARE REDUNDANCY(LIKE
COMPUTER MONITER)

Answer / vsdfgv

udhsudhasjfhseafdudehnfksdh

What is zener diode? What is voltage regulator?

0 Answers  

---

Where we r using split range and ratio controller?

1 Answers   EID Parry,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

what is type of protocol used in instrument field to marshalling cabinet cabel. what is the differenance between bus cabel and instrument cabel?

1 Answers   Samsung,

---

I need the intools training institute address in india. Intools subject oriented local authors books.Refer me plz

3 Answers  

---

what is the criteria to decide conductor size of a cable ?

0 Answers  

---

What are the two program execution modes of PLC?

4 Answers  

---

How r the calculation of process line mpm.

0 Answers   Bhushan Power Steel,

---

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

0 Answers  

---

list of flame proof certification ?

1 Answers   TATA,

---

Explain an adaptive / self-tuning controller’s major draw card.

0 Answers  

---