Answer / shyamkr

the dc ectified voltage will be 230 v only.....

Answer / jaywant

230volts only

Answer / guest

dc output value will be actually the rms value.
RMS value of input=230 volts
max value of input=230*sqrt(2)=325.27 volts
since no transformers are used,
max output=325.27 volts
Therefore,dc output voltage=rms value of 325.27=
(2*325.27)/3.14=207.07 volts

XYZ

0 Answers   ASD Lab,

---

why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?

0 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

What does the temperature (30 deg or 35 deg celcius) mark on conservator of transformer indicates?

2 Answers   MahaGenco,

---

How to calculate or testing the KW in generator

1 Answers  

---

In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is

0 Answers   Caterpillar,

---

What is the difference b/w earthing & grounding?

6 Answers  

---

I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN

0 Answers  

---

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

0 Answers  

---

Does power factor vary with speed?If yes, how?If not, why?

4 Answers   Genco,

---

if voltage is not builed up in small generator what will be the reason?

7 Answers   century,

---

How can you calculate in detail the VA burden of current transformer used for Restricted earth fault protection? Please understand that the CT required here is Class PX or X. Also please show the calculations for knee point vtg, stabilizing resistor, magnetising current.

3 Answers  

---

i want wipro vlsi placement pattern please send me

0 Answers  

---