Why sip ring used in ac motor also why its not used in dc motor?

Question Posted / ravi tandel

2 Answers
7229 Views
RRB, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why sip ring used in ac motor also why its not used in dc motor?..

Answer / r g sabnis

Well, the slip rings are used in AC ( Crane duty Motors )

to add extrenal resistance to increse starting torque.

DC motors are with different construction. A commutator is
used to supply DC to armature.

Is This Answer Correct ?

4 Yes

2 No

Why sip ring used in ac motor also why its not used in dc motor?..

Answer / dj

Actualy for better torque in induction motor we should have high resistance and low inductance but in induction motor we have coil which have high inductance so we give high resistance from rheostat to rotor. And we use slip ring because it is use for rotating device only in ac motor

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning

0 Answers

What is the difference between analogue electronics and digital electronics?

2 Answers PSU,

i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.

0 Answers

Why stand-by earth fault relay and restricted earth fault relays are connected between neutral and ground in transformer?

1 Answers

What are the difference between off-load tap changer and on-load tap changer in transformer?

2 Answers HCL,

How Can we calculate current carrieng capacity of Copper Bus-Bars and Alluminium Bus-bar

2 Answers

Dir sir we have 750 kva Caterpillar dg set we are fas on different problem we start dg set ofter 1 mint apply load around 500a dg was run one or 3 mint after 3 mints dg was shutdown automatic how to face tis problem

3 Answers

Why earthing done?

1 Answers CBRE,

Can you explain operating principle of Inverse Definite Minimum Time” (IDMT) relay

2 Answers

what is the difference between surge arrestor and surge supressor

1 Answers

what would happen if u assume to insulate all the overhead lines and no insulators....??do you think it to b an advantag or a disadvantage??justify.

3 Answers

As the one point of eac phase winding is connected to each other in satr connction. Even if that at distribution side collesion of two diff phases result in to blast. Why?

1 Answers

For more Electrical Engineering Interview Questions Click Here