Answer / azcest@gmail.com

yes,the copper loss is depend as the diameter of winding
coil.The coil diameter are inversely proportional to the
resistance of winding coil.The copper loss = square of
current*resistance .the value of current are depend as the load.

Answer / ankamsreekar

it can be possible by using low specific resistance
material for winding.

What will be the output of t/f supplied with DC sourse?

2 Answers  

---

we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes

0 Answers  

---

Why motor initial starting current is high?

9 Answers   Pennar,

---

different between circuit breaker & switchgear & relays

6 Answers   EFS,

---

will the power consumption remains the same when speed of the fan cnanges??if so y??

2 Answers  

---

For which purpose the temp. rise test of transformer is conducted?

2 Answers  

---

what is the difference between the electrical and electroncis

15 Answers   TCS,

---

i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh

0 Answers  

---

Why we use a shunt capacitor or synchronizing Motor To Improve a Power factor pls reply me in this mail dinesh_elect_eng@yahoo.com

4 Answers  

---

A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.

0 Answers   Jindal,

---

A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be

2 Answers   L&T,

---

I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.

0 Answers  

---