how can u do the earthing of an aeroplane?
Answers were Sorted based on User's Feedback
Answer / sudarsanarao
Plane is travelling in Air. i.e. it is isolated from earth.
So there is no requirement of earthing.
Ex. If lightnng come to plane,there is no path to ground.
then it seems another path to discharge.
rao.sudarsan@gmail.com
Is This Answer Correct ? | 14 Yes | 4 No |
Answer / mistry jay
Mr rao lightning are of 2 types 1 from sky to ground and 2 groud to sky what about that?
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / gunasekaran
it is flying very high speed duu due to the friction with
air electrical neutralisation will be distrube so it
getting charged so it may be catching fire so at the time
of landing first earth wire put it on ground so charged
iron go to ground so no problem due to charging.
Is This Answer Correct ? | 4 Yes | 5 No |
Answer / abel akponah
By connecting the earth from the star piont of the
generator
Is This Answer Correct ? | 0 Yes | 13 No |
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
WHEN THESE TRANSFORMERS WINDINS CONFIGURATION ARE USED? SPECIALLY EXPLAIN REGARDING STEP UP AND STEP DOWN KEEPING IN MIND.AND REGARDING LOAD ALSO. a.star to delta b.delta to star c.delta to delta d.star to star ALSO EXPLAIN WHY V USE 415/415 TRANSFORMERS IN TUBEWELLS?
How to connect surge arrester with equipment?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
how the 3phase induction motor is running in 2phase supply with help of capacitor?
what is difference between inductive and reactiveload?
One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness...explain
what is the use of terminals in transformer ?
1 Answers Core Solutions, Honeywell,
What are the types of circuit breakers ?
How to design CT for connected with Transformer OLTC operation? normally CT output design for 1A/5A range but during OLTC Tap position changing time how to function the CT?
what is the disadvantage of lagging power factor & why ?
why wave traps are placed only at y and r phase?