What is the use of insulation tester and how it is to be
used.

Answers were Sorted based on User's Feedback



What is the use of insulation tester and how it is to be used...

Answer / pillay

Insulation tester is used for as the name says to determine the
level of insulation available. Insulation is measured in units of
ohms. and the higher the readings the better is the electrical
insulation.The test is done across the conductor and its insulation.

Is This Answer Correct ?    3 Yes 0 No

What is the use of insulation tester and how it is to be used...

Answer / thowsif_csm_emerson

An insulation tester can be used to determine the integrity
of windings or cables in motors, transformers, switchgear,
and electrical installations. The test method is determined
by the type of equipment being tested and the reason for
testing.

For more information log on to:-

http://www.electricityforum.com/test-equipment/insulation-
tester.html

Is This Answer Correct ?    4 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?

0 Answers   Semac,


How to calculate KW saving for power factor correction from 0.92 to 0.98 at 350KW load?

5 Answers   Heidelberge Cement,


what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB

0 Answers  


A 40 kva transformer has a core loss of 400W and a full load copper loss of 800W. What is The proportion of full load at maxmimum efficiency?

1 Answers  


Difference Between Isolator and Mcb

13 Answers   VHB Medi Life Sciences,






What happen when change order of CT in GIS feeder?

0 Answers  


What is fault level?How it is calculated and how it is Expressed?

2 Answers  


In a 3 phase squirrel cage induction motor why does rotor rotate? will 3 phase transformer rotate like a motor if it is placed on bearings and powered up? give reason

10 Answers   Siemens,


what is phase to phase voltage? what is line to line voltage

46 Answers   Exmar, HBL Power Systems,


Advantage of LT panel vs HT panel

0 Answers  


if current required for triggering thyristor at -30 degrees(temp) is 80 mA, what is the current required at 60 degrees

1 Answers  


why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16637)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)