Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of insulation tester and how it is to be
used.
- 2 Answers
- 4871 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
Insulation tester is used for as the name says to determine the
level of insulation available. Insulation is measured in units of
ohms. and the higher the readings the better is the electrical
insulation.The test is done across the conductor and its insulation.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is current check gurd relay?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
what are pilot cells
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
how withstand of hi-pot test outputs of transformer wire 2.5mm
how to design coil turns ?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
Which is the largest hydropower station in the world?
what is meant by directional earth fault and non directional earth fault? describe both.
in shunt clippers why a resistor is used in sereis with the input
WHAT IS counter flux IN CT?
draw 3 phase rectifier diagram
what is per unit calculation?looking for simple and strong explanation thk u
