why t/c is connected parallel and what is the purpose of it

Question Posted / girish

2 Answers
6677 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why t/c is connected parallel and what is the purpose of it..

Answer / biswarup das

T/c is connected in parallel(not always though)as its emf
remain same doesn't matter how mant t/c is connected in
parallel only(note this is not applicable in series connection)

one purpose is the measurement of average temperature
between several locations. The easiest way to do this is to
connect several thermocouples in parallel with each other.
The milli volt signal produced by each thermocouple will
average out at the parallel junction point. The voltage
differences between the junctions drop along the resistances
of the thermocouple wires.

Is This Answer Correct ?

6 Yes

1 No

why t/c is connected parallel and what is the purpose of it..

Answer / u.nathan

bcoz output is voltage

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?

0 Answers GNFC,

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers GMR,

What is the difference between a Extension cable and a copnesating cable.Where can we use compensating cable. Is anywhere compensating cable are used for mv transmission to the indicator.

1 Answers

Difference between guide wave radar & non guide wave radar ?

1 Answers UPL,

What are different type of instrument cable

0 Answers KOC,

which instrument is most commonly used to observe the external features of a grasshopper's abdomen?

1 Answers

dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.

0 Answers CPL,

what is difference between differial pressure & delta pressure?

3 Answers

Difference HAZOP and HIRA

1 Answers

If you calibrate a pneumatic pressure transmitter, how many adjustments are normally necessary or mandatory?

1 Answers

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers Siemens,

What is safety barrier and how it is work

2 Answers IOCL,

For more Instrumentation Interview Questions Click Here