What is difference between reset and initialization in industrial automation?

1 Answers   Marafiq,

---

What does a hookup diagram look like? can you give sample drawing. thanks.

1 Answers  

---

what is intrinscily safe system and where we use?

0 Answers   DEWA,

---

What are the disadvantages of Human-Machine Interface (HMI)? atleast 3.

1 Answers  

---

why twisted pair of wires is used in instrumentation ?

6 Answers   ONGC,

---

What is the difference between pneumatic and electro pnematic positioner?

3 Answers   TCS,

---

1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?

0 Answers  

---

what is the calibration procedure for magnetic flow meter @ onsite

0 Answers  

---

1)unmovable objects have frequency or not?if that object have frequency,how do we measure and transmit? 2)how do u measure the continuity without multimeter? 3)we put 24volt dc supply in railway track how many distance it is traveled without voltage drop?

1 Answers  

---

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers  

---

I am pujita completed Electronics and Instrumentation Engineering.As a fresher i am going to attend the interviews.Could anybody guide the topics/questions covered mostly in interviews.

11 Answers  

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---