Interested to Buy Any Domain ? << Click Here >> for more details...
why t/c is connected parallel and what is the purpose of it
- 2 Answers
- 6681 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswarup das
T/c is connected in parallel(not always though)as its emf
remain same doesn't matter how mant t/c is connected in
parallel only(note this is not applicable in series connection)
one purpose is the measurement of average temperature
between several locations. The easiest way to do this is to
connect several thermocouples in parallel with each other.
The milli volt signal produced by each thermocouple will
average out at the parallel junction point. The voltage
differences between the junctions drop along the resistances
of the thermocouple wires.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
How ejector(or)evactor air pump is working in thermal power plant?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
can u briefly explain aboutan aryton shunt multirange DC ammeter?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
What are the uses of orifice plates?
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
what is cems analyzer explain with principle and drawing ?
all questions related to instrument technician in any offshore oil and gas company.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
