what is wave trap? please explain the working and principle

Question Posted / ravimenon

4 Answers
36737 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is wave trap? please explain the working and principle..

Wave trap is a parallel tuned inductor - capacitor 'tank'
circuit made to be resonant at the desired communication
frequency.
It is the effort to utilize the same transmission line
between two substation for the purpose of communications.
At this communication frequencies the tank ckt provides
high impedance and does not allow to pass through them &
onto the substation bus & into transformers.

Is This Answer Correct ?

73 Yes

4 No

what is wave trap? please explain the working and principle..

Answer / faizan

wave trap is used for filtering high frequency communication signal from power signal.
Line trap also is known as Wave trap. What it does is trapping the high frequency communication signals sent on the line from the remote substation and diverting them to the telecom/teleprotection panel in the substation control room (through coupling capacitor and LMU).
This is relevant in Power Line Carrier Communication (PLCC) systems for communication among various substations without dependence on the telecom company network. The signals are primarily teleprotection signals and in addition, voice and data communication signals

Read more: http://wiki.answers.com/Q/How_does_wave_trap_works_in_a_substation#ixzz1yagTB1zk

Is This Answer Correct ?

28 Yes

2 No

what is wave trap? please explain the working and principle..

Answer / gamit ankit f.

wave trap is used for filtering high frequency communication
signal from power signal.
Line trap also is known as Wave trap. What it does is
trapping the high frequency communication signals sent on
the line from the remote substation and diverting them to
the telecom/teleprotection panel in the substation control
room (through coupling capacitor and LMU).
This is relevant in Power Line Carrier Communication (PLCC)
systems for communication among various substations without
dependence on the telecom company network. The signals are
primarily teleprotection signals and in addition, voice and
data communication signals

Is This Answer Correct ?

9 Yes

2 No

what is wave trap? please explain the working and principle..

Answer / anjali brahmi

wave trap is the instument which used to reduse the corona
loss in transmission line in power system and in this a
parellel tuned inductor -capacitor tank circuit made to be
resonant at the desire communication
it effort to utilise the same transmission between two
substations for the purpose of communication

Is This Answer Correct ?

9 Yes

49 No

Post New Answer

More Electrical Engineering Interview Questions

Why does amplifier gain reduce?

0 Answers

what is STUB protection in tranmission system and switch yard area?

9 Answers KSEB, Power Grid,

If a high resistance fault occurs,then what are the changes will happen in the system?

0 Answers

What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?

0 Answers HPCL,

two phases with neutral supply can be taken in 3C X 10 sq.mm cable .

0 Answers SPCL,

What is short circuit analysis of electrical networks?What are the procedures to be followed for its calculation?

2 Answers DLF,

I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com

0 Answers

deisel generators all elcetical calculation formule's

1 Answers

why zero sequence impedance measurement is not applicable for single phase GT

0 Answers

when we increased the current what do ?

0 Answers

why power factor occur only inductive load not in resistive ?

8 Answers

iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.

0 Answers

For more Electrical Engineering Interview Questions Click Here