what is wave trap? please explain the working and principle
- 4 Answers
- 35241 Views
- I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
Wave trap is a parallel tuned inductor - capacitor 'tank'
circuit made to be resonant at the desired communication
frequency.
It is the effort to utilize the same transmission line
between two substation for the purpose of communications.
At this communication frequencies the tank ckt provides
high impedance and does not allow to pass through them &
onto the substation bus & into transformers.
| Is This Answer Correct ? | 73 Yes | 4 No |
Post New Answer View All Answers
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
Define norton equivalent circuit?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
what is the safety of voltage power transformer(2250KVA0
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
Why is a plain induction motor unsuitable for wide speed control?
Why power factor should not be in leading (capacitive) mode of any load.
What are the properties of a resistor?
What are the advantages of the three-phase motor over single phase motor?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
for what purpose the star point is done in ct
