What is Diff btw MCP & MCB????
Answers were Sorted based on User's Feedback
Answer / suhana
MCP:-Manule Call Point
It is used in Fire Alarm Systems,it is a switch to operate
in case of any emergines or in the event of fire..
MCB:-Maniature Circuit Braker
It used used as a protecting device in elcetrical
installtions.
| Is This Answer Correct ? | 97 Yes | 11 No |
Answer / khubaib
No, MCP here is more related with MOTOR CIRCUIT
PROTECTOR...while MCB is MINIATURE CIRCUIT BREAKER.
| Is This Answer Correct ? | 32 Yes | 8 No |
Answer / b. kasthuri
MCP Is the Manual Call Point which is used for fire
indication whereas MCB is the Miniature Circuit Breaker
which is used to trip the circuit when fault occured.
| Is This Answer Correct ? | 32 Yes | 9 No |
MCB IS A MINIATURE CKT. BREAKER THAT USED IN ELECTRICAL
WIIRING AS A PROTECTIVE SWITCH FOR MEDIUM RATING PROJECTS.
| Is This Answer Correct ? | 17 Yes | 4 No |
Answer / sreemani84
MCP - Manual Call Point
MCB - Maniature Circuit Breaker
| Is This Answer Correct ? | 16 Yes | 5 No |
Answer / nitin
mcp is the manual call point which is usd for fire
indication where as mcb is the miniature circuit breaker
which is usd to trip the circuit when fault occured.
| Is This Answer Correct ? | 16 Yes | 6 No |
Answer / engr
MCP Motor Circuit protection
MCB Miniature circuit breaker
| Is This Answer Correct ? | 14 Yes | 5 No |
Answer / bhawna tiwari
MCP - manual call point, is an alarm system which is used
in case of fire or any emergency.
MCB - Miniature Circuit breaker is used an a trip system to
protect the entire electricity points.
| Is This Answer Correct ? | 10 Yes | 3 No |
Answer / felipe
MCP: Motor Circuit Protection
MCB: Main Circuit Breaker
Those are two abreviattions referred to NEMA
This difference is usual in MCC where you have, for example, MCP for motor starters (NEMA 1,2,...), and MCB other kind of loads, for example AFD or SS
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / mukesh
mcp stand for manual fire alarm where mcb stand for miniature circuit breaker
| Is This Answer Correct ? | 0 Yes | 0 No |
Which Programming software are use for Allen bradley PLC's?
What shall be the minimum distance to be maintained between two power cable in a common trench?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
wich types of current?
what is REF relay?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Hello friends, Can anyone explain the concept of zones in Bus bar protection and how can we differentiate the main zone and check zone in Bus bar protection
what type of insulation is used for over head lines?
wat is mean by HRC fuse... WHY we choose it...?
how to calculte capacitor range for single phase induction motors??pls tel
WHAT IS START TO >5HP INDUCTION MOTER IN STAR DELTA METHOD?
what is 3 phase motors
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)