iam using DM 3251 voltmeter(1 percent accuracy)for 11KV
system PT ratio is 11KV/110V.can anybody explain what is
the max and min voltage deviation.
No Answer is Posted For this Question
Be the First to Post Answer
What happens on the secondary of a 33kV/11kV when one phase of the primary fuse blows?
usually why bettery voltage are 1.5V, even if you open a 9V battery there are six 1.5V batteries in series. is it not possible to increase this voltage other than putting in series
what is the speed of electricity?
my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?
An automatic water heater is an example of which type of control system?
why we test the core balance of the transformer?
66kv under ground cable how to layaing in ground any special case two ckt r runing
what the reson to use phase shift( angle) like (dyn11,Dd5 or Dy0)are usedin power and transsmison line
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
The Source internal resitanse Rs , When equal to Load resistance RL, the maximum transfered is of _____ % of input power?
my first school?
WHY CAN WE NOT CHAGE SPEED OF SYNCHRONOUS MOTOR...............................JUSTIFY