Answer / mh

N1/N2 = V1/V2 = I2/I1

Answer / sanjeev

N2/N1=V2/V1=I1/I2=k


N2=number of secondary turns
N1=number of primary turns
V2=secondary voltage
V1=primary voltage
I1=primary current
I2=secondary current

For Impedance use:

(N1/N2)^2=Z1/Z2

Answer / anand kumar c

N2/N1=V2/VI=I1/I2=Transformer Turns Ratio

Answer / gayaselec

N2\N1=V2\VI=I2\I1

Answer / suhas

N1/N2=V1/V2=I1/I2

What is the formula to calculate the rating of power cable for three phase current.

0 Answers  

---

why there is 1 phase and 3 phase but not 2 phase and 4 phase?

3 Answers  

---

what is the meaning of x,m,k in the relays?

0 Answers   ITC Infotech,

---

Find active & Reactive Power transmitted in a transmisston line having Vs30 degree(sending end) to Vr(zero degree)at receving end with line inductance X ohm. Vs(30degree)-------------------Vr(zero degree) X ohm

3 Answers  

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor frequency at maximum torque point is A 3.33% B 4.44% C 5.55% D 6.66%

1 Answers  

---

---

WHY DISEL GENRATOR SET SHUT DOWN IN OVER LOAD CONDITIONS

5 Answers   HMT,

---

how to do the ductor test?

0 Answers  

---

why the transformer neutral earthing is to be done by copper flat only,if we use GI flat what is the disadvantage.

2 Answers  

---

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers  

---

what is the difference between EMF and potential difference??

3 Answers  

---

Pleasd Tell Me..... In Generating Stations Why The Generation Of ELECTRICITY Is In 3 Phase Form?? OR In Generating Station Why We Generates The ELECTRICITY In The 3 Phase?? Why Not In The 4 Phase, 5 Phase Or 6 Phase Form??

3 Answers  

---

how does a shunt reactor maintains the bus voltage???

0 Answers  

---