on what factor insulation resistance depends
Answers were Sorted based on User's Feedback
length and cross sectional area of rated cable
| Is This Answer Correct ? | 7 Yes | 2 No |
what is a relation of energy in electromagetic field
what is the use of interposed & reverse voltage transformer
in three phase with neutral connection, what will happen,if the neutral is in open condition with single phase distribution panel ?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
I find that underground strip-armoiured,4core,LT PVC cables in an earthed power distribution sytem are occasionly found in charred condition-with no trace of it except ash. Is this because of no proper earth connection/continuity (giving rising to high armour resistance)in the joint enroute or because of insufficient capability (again due to high armour resistance)of cable-armour to carry fault current or due to neglected /unprotected overloading of the cable or due to high armour currents caused by power thefts where only phase(s) are unauthorisely tapped & at the point of poer consumption earth terminal is established by burring underground a not so good earthing rod (or using an underground water pipe for the purpose)
y we are used signal conditioner in capacitive transducer
what is cathodic protection and why it use in industries?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
In Railway,why we are used HT Line 25KV ?.why we are not used 11KV,33KV and others for This?
37 Answers Airtel, BSNL, RRB,
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
why and how fault current flows through ground?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)