Answer / rajesh lande

is there any negative marking system in exam held at 14
march 2010. if yes then plz tell me % of marking system.

what is the advantage by using PID controller than P& PID?

1 Answers  

---

Isometric drawings are generated during _________________ phase of a project

0 Answers  

---

what is the dp across a orifice plate & how much is permanent pressure across an orifice plate.

2 Answers   HPCL,

---

which type of filter gives the constant phase characteristics?

0 Answers  

---

what is the diffrene between DCS System and PLC System

5 Answers  

---

i have a dp tx range is 5000mmwc. in which calibration i use in a open tank.1.5*3.5*2.5 mtr.for level msmnt. what is the calculation.

2 Answers   Bajaj Hindusthan,

---

What are SMART insuments?

5 Answers  

---

can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.

0 Answers  

---

How to Calibrate Temperature Switch in field

0 Answers  

---

What you mean by multi stage control vavles?

0 Answers  

---

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used?

2 Answers  

---

in split range control valve,two valve should be in two different line and that should have some distance,and we have only one positioner feed back link.so how we connect one feed back in two control valves?if you have picture please forward me.my email id kb.syamkumar@gmail.com

2 Answers  

---