Answer / bunny

By using a PID controller we can eliminate the offsets and
unwanted oscillations of the process variables we are
dealing with and will get the process variable value close
to the set point value.For that we need to tune the
controller properly and select proper values for P,I and D

What is re-latch the manual trigger in solenoid valve

0 Answers   Valvitalia Systems Division,

---

what are the possible reasons if a control valve fails to open/close?

1 Answers   DEWA,

---

Are Coils of Electromagnetic flowmeter in direct contact with fluid material

4 Answers   TATA,

---

Is it possible to drill additional gland hole in EExd or EExe JBs? What are the points to take care?

2 Answers  

---

hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com

0 Answers  

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

0 Answers   Chevron Phillips,

---

What are de-saturators?

0 Answers  

---

What is the syllabus for Instrumentation Engineers, who wish to join the Public Sector Units??

1 Answers  

---

Controller not working in auto mode?...what are the problem can occur...Pls explain

1 Answers   Aramco,

---

What is seismic transducer?Where it is used?

1 Answers  

---

Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system

0 Answers  

---

Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?

0 Answers  

---