Answer / glen saldanha

No this is not possible This control is also called as ward
leonard control. in which motor and generator are coupled .
the reason why it will not work is because of the losses in
both the motor and the generator.the main losses is due to
friction.
it goes like this due to the friction in the generator this
apply more load on the motor,the motor will try to draw
more current from the generator.this will continue for some
time there will a point that the speed will slow and the
generator cannot fulfill the requirement of the motor and
eventually stop.

Answer / pillay

remember a few basic truths ,
you cannot make something out of nothing
nobody has made anything in this world only
transforming something to something else.

the answer your question is "impossible".

Answer / vijay raskar

No,never.its impossible.because, total supply is zero. As battary create some kind of electricity. It is very less for motor to run.

Answer / suresh5254

It is not possible.........to do so either motor or
alternator efficiency should be more than 100% which is not
possible.....
Ex.. let motor i/p power= P1
o/p power= p2
generator i/p power= q1
o/p power= q2
here p2 cannot be more than p1 ,lly q2 cannot be more than
q1 because of copper,friction and windage losses......so
obviously q2 lesser than p1....so motor cannot run

Note: Energy neither be created nor destroyed...only it can
be transferred from one form 2 other....

Answer / saleem

Yes it is possible.

if the generator is generate more power then the motor
consumed.
OR
If motor is consume less power as compare generation of
power.

Exm If motor consume 1kw to rotate the alternator than
alternator generate 1.5kw then we can use .5 kw in other
uses.

Please Design such alternator and motor.

in alternator how we can give power to rotor ? its power is AC or DC ?

5 Answers  

we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?

0 Answers   IGC,

How dia computation perfomed in cold rolling mills .

0 Answers  

What is a soft start?

4 Answers  

how we calculate the withstansing current capacity of wires&cables?

0 Answers  

When we are working on transformer(132\11KV). we are going to isolate the transformer from both HV side and LV side. then we are applying grounding on both side. My question is that we required to isolate the VT which is still connected from secondary side.?

1 Answers  

what is plunger and what's the use of it in motor alignment?

0 Answers   CLZ, Yahoo,

Whats changes in Transformer Oil BDV in changes in temp or Climate?

2 Answers   TATA,

Hi friends. m 3 years drop. now d company asks in d interview d reason 4 my drop.what shud b d probable answers 4 that which may not put a negative impression.

2 Answers  

draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups 

0 Answers  

why on delay timer used for fully automatic star delta starter?

0 Answers  

how to check the earth resistance value& what is the minimum earth resistance for good earthing sysytem.

33 Answers   Brookfield, BSNL, DMRC, Epoch, KPTCL, Polycab, Power Control, SIEA, Siemens, Wipro,