what is the thumb rule to know current carrying capacity of
copper conductors of different size.
Answer / wareagle
The rule of thumb is to look it up in a table.
| Is This Answer Correct ? | 0 Yes | 2 No |
What are the advantages of DOL starter?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
Dear All, Can anybody please tell me which value(saturated or unsaturated) of sub-transient reactance(Xd") we take for the calculation of fault current of the system?
how can I improve the current at same voltage? if yes is there any circuits?
what is the difference between OD and VL
why we choose 50 or 60 hertz not other value for the power system?
we have 1000 litre water tank,it located at 25m hight from ground level,the water level on 10m below from ground level.for fill the tank within 1 hour,how much of motor rating(HP) want to select?
Off-circuit Tap changers in distribution transformer required
is dc transformer is possible ?
what do you mean by mf of energy meter & its formula?
why ac wave is sinusoidal not square or triangular wave what will be reason
how to calculate transformer load?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)