In Megger which types of test we can do ? and How it works? How to use?

Answers were Sorted based on User's Feedback



In Megger which types of test we can do ? and How it works? How to use?..

Answer / t. krishna moorthy

insulation resistance with respect conductor to ground &
between two conductors insulation value.

Is This Answer Correct ?    12 Yes 0 No

In Megger which types of test we can do ? and How it works? How to use?..

Answer / guest

EARTH RESISTANCE TEST. IT IS MEASURED IN OHMS

Is This Answer Correct ?    3 Yes 2 No

In Megger which types of test we can do ? and How it works? How to use?..

Answer / nandagopan

for 3 phase motors megger is used to test the insulation
resistance of motor winding.phase to earth(winding to body)
must be greater than 1 mega ohm.

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

in a three pin socket y the pin of earthng is longer n bigger...?

3 Answers  


will there be any problem by recovering slip from single phase induction motors?

0 Answers  


how will you calculate rated Primary and Secondary voltage and Current for 2500 KVA, 11kv/443V Transformer

2 Answers  


plz tell me Motor IP formula

0 Answers  


What is the unit of magnetic flux density?

0 Answers  






What is the difference between power,voltage,current? and with example

3 Answers  


if transmission voltage expressed as the multipple of form factor(1.11)........11,33,66,220 etc......then why madakkathara substation(kerala) voltage is 400kv..not 440.....?

2 Answers   KSEB,


50 electric bulbs are connected across supply of 220 volts. After one bulb is fused remaining 49 bulbs are again connected to same supply. which case will have more illumination & WHY????????

5 Answers   KJ,


How to calculate the Meter constant for the given Meter (by using any formula)

4 Answers   HCL, Viva,


is KVAR (not reverse power) relay necessary to protect from excitor field failure on a brushless, synchroneus generator? Some people with previos experince tell me no but the manufacturers tell me it is designed for that purpose. Is it that it is only necessary for brushless generators and not the older style with the slip rings and brushes?

1 Answers  


what is purpose of manual bybass in ups

3 Answers  


describe the fully control circuit diagram of ac drives

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4452)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)