why protection and metering CT's are always connected in
star why not in delta?
Answers were Sorted based on User's Feedback
Answer / mahesh sali
in order get the neutral point for earth fault protection
and differential protection ct always connected in star,
ct also used for overload protection by measuring the
balance phase current.
Is This Answer Correct ? | 12 Yes | 5 No |
Answer / felixraj
for getting phase measurement and protection
Is This Answer Correct ? | 10 Yes | 10 No |
Answer / arvindpanchal75
ALL CT'S CONNECTED IN STAR CONNECTION BECAUSE C.T MEASURE THE PHASE CURRENT,
Is This Answer Correct ? | 1 Yes | 4 No |
why the NGR (neutral grounding resistor) always OFF during DG off?
What the capacitor Current formula?, For 1 KVAr how amps its required? for using the KVAr for boosting the PF Design Calculation.( Eg: for 30 KVAr required how many KW?)
17 Answers Alstom, Call Centre, EDC, HCL, Procon Engineers,
What is the difference between amorphous core transformer and CRGO core transformer?.
What will happen if we give AC supply to DC motor?
what is the value of current as well as voltage upto which we will not feel shock and why?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
why a diode bridge is provided in vcb control circuit ?
What is the need of black rock stones under the transformer yard?
5 Answers TNEB Tamil Nadu Electricity Board,
what is difference between start imitation and start interlock for 3 phase motor protection ?
How will change the frequency in distribution side?
IS there any special instructions to be taken while installing the tranformer.
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..