Interested to Buy Any Domain ? << Click Here >> for more details...
why protection and metering CT's are always connected in
star why not in delta?
- 5 Answers
- 12914 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / felixraj
for getting phase measurement and protection
| Is This Answer Correct ? | 10 Yes | 10 No |
Post New Answer View All Answers
what is the Pickup/drop off ratio in BCPU relays
how much GROUND & NEUTRAL VOLT maintain in data center.
how to synchronize 3 phase slip ring induction motors of different ratings.
What is difference between start imitation and start interlock for 3 phase motor protection ?
Mention how NPN and PNP transistor works?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
what is effect of leading power facter on the system and billing
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
what is the use of Auto re-closer?
Why auxiliary transformers are not connected in parallel in primary stations?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
how can you size an automatic voltage regulator?
What is the physical significant of power factor?
