Interested to Buy Any Domain ? << Click Here >> for more details...
why protection and metering CT's are always connected in
star why not in delta?
- 5 Answers
- 13119 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / shahin
Because the star point is needed to be grounded. Which
isn't possible in delta system....
| Is This Answer Correct ? | 20 Yes | 13 No |
Post New Answer View All Answers
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
How to calculate earth wire load by formula
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is sensitivity of a measurement?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
What consists of 2 or more thermocouples to be connented series?
how is calculated the quantity of weight in hot test xlpe?
I need HT sphere gap calibration table. Can any body help me.
how we can explain arc heatng?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
